Asphalt Paving & Repair

Asphalt Paving & Repair2018-08-03T07:54:55+00:00

Paving

Whether it’s a city street or a parking lot, entrust Midwest Coatings to lay a new asphalt surface.

Asphalt Resurfacing & Overlay Process

A close up of an asphalt roller.

Step One

Identify and repair base failures.

Existing pavement is swept.

Step Two

Sweep existing pavement surface.

A midwest coatings worker uses a long tool to spread asphalt across a crac.

Step Three

Apply tack coat.

New asphalt surface material is installed using one lift of a dump truck.

Step Four

Install 2” compacted thickness of Hot Mix Asphalt surface material in one lift.

Partial & Full Depth Repair

Patch and repair failed and damaged pavement on commercial, industrial, residential, county, and other surfaces to restore asphalt and prevent further distress. A partial depth repair fixes asphalt damage without milling down to the base, while a full-depth repair gets all the way down to the pavement base.

Partial & Full Depth Repair Process

Existing pavement is milled by an MWC crew member.

Step One

Mill existing failed pavement to a minimum depth of 2” (partial depth), up to 8” (full depth).

A crew member blows compressed air into a crack to clear it of debris.

Step Two

Blow area with compressed air.

Tack coat is applied.

Step Three

Apply tack coat

New Hot Mix Asphalt is installed on the pavement surface.

Step Four

Install new Hot Mix Asphalt material flush with surrounding pavement surface. Full depth repair shall be installed in multiple lifts.

The perimeters of repair area are routed and sealed.

Step Five

Rout and seal perimeter of repair area.

Large Crack Repair

Are your cracks too large to be sealed with sealant or slurry? Midwest Coatings has been performing professional crack repair for over 20 years.

Crack Sealing and Repair (Large Crack Repair)

A photo of a milled crack.

Step One

Mill existing crack to a minimum depth of 2” (partial depth) or up to full depth of existing pavement.

Cracks are blown with compressed air.

Step Two

Blow with compressed air.

A crack with tack coat applied.

Step Three

Apply tack coat.

New Hot Mix Asphalt material is prepped by MWC workers.

Step Four

Install new Hot Mix Asphalt material and flush surrounding pavement surface. Full depth repair shall be installed in multiple lifts.

Perimeters of repair area are routed and sealed.

Step Five

Rout and seal perimeters of repair area.

Looking for Asphalt Subcontractors?

Contact Us